Guaranteed Fitment
Always the right part
x
x
have questions?
Always the right part
Before 2pm EST*
Original Equipment Manufacturer Part #: 11267S00010
Catalog SKU:
RHS #:
Compatible with:
Note: for use with 1267 hinge
Compact switch, automatic switch to control light, fan or other electrical device. Fits within base of 1267 hinge. Leads attached for easy installation. Order hinge and switch separately. Compact switch for automatic control of light, fan or other electrical device.
Reg. U.S. Pat. & Tm. Off. http://kasonind.com/IP
Need additional help? Give us a call at (877) 442-7538 Monday-Friday 8am-5pm EST or via email info@gasketguy.com.
Corner Options
Standard
The most popular, the corners are square (90 degrees) and have been finshed so they are safe to handle.
Rounded
The corners are rounded at about a 1/2" radius. Typically people will round the corners if they walk past the board often in a commercial kitchen.
Unfinished (Saw Cut)
Not very common, there is no finishing and the corner is sharp.
Edge Options
Standard
The most popular, the edges of the board are square and have been finshed (deburred) so they are safe to handle.
Bullnose
We will round the edges so they are not square, often referred to as rounded.
Unfinished (Saw Cut)
Not very common, this is just like it says. No finishing, edges are sharp. Typically people use this option in custom applications.
Juice Grooves
Also commonly referred to as juice troughs, juice grooves are one of our most requested customizations. We simply route a small trough around the perimeter of your board to catch drippings from carving meat.
Number of Sides
4 Sided - Most common for refrigeration door gaskets. Gasket goes around all four sides of the door
3 Sided (2 Long, 1 Short) - Typically seen in cooler / freezer walk in doors. Walk in doors often have a door sweep at the bottom that replaces the bottom side of the door gasket
3 Sided (2 Short, 1 Long) - Least common for refrigeration door gaskets. Occasionally drawers gaskets have 3 sides
Short Side / Long Side
To custom make a gasket we need to know the outside edge dimensions of the gasket. For "Short Side", please measure the shorter of the two sides and enter the dimension into the drop downs. The whole number goes into the first drop down and the fraction goes into the second drop down. For "Long Side", please measure the longer of the two sides and enter the dimension into the drop downs. The whole number goes into the first drop down and the fraction goes into the second drop down. Make sure you're measuring outside edge dimensions of the gasket, from outside corner to outside corner.
